Error Message "ModuleInfo class is incorrect"
Mike
none at none.com
Thu Dec 5 05:26:39 PST 2013
On Thursday, 5 December 2013 at 07:06:48 UTC, Kai Nacke wrote:
> Hi Mike!
>
> On Thursday, 5 December 2013 at 01:11:13 UTC, Mike wrote:
>> I'm trying to port the D Runtime, incrementally, to the ARM
>> Cortex-M (thumb2) platform. But after bringing object.d in,
>> I'm getting this error message:
>>
>> "object.d ModuleInfo class is incorrect"
>>
>> Looking through LDC's source code, I found the following in
>> toobj.cpp
>>
>> // check for patch
>> else
>> {
>> #if DMDV2
>> unsigned sizeof_ModuleInfo = 16 * PTRSIZE;
>> #else
>> unsigned sizeof_ModuleInfo = 14 * PTRSIZE;
>> #endif
>> if (sizeof_ModuleInfo != moduleinfo->structsize)
>> {
>> error("object.d ModuleInfo class is incorrect");
>> fatal();
>> }
>> }
>
> Are you sure you are looking at a LDC source file?
> driver/toobj.cpp does not contain this piece of code. The error
> message is produced in gen/module.cpp.
>
>> I'm not sure if PTRSIZE is not properly defined for my
>> platform, or if I need to make changes to ModuleInfo, or some
>> other problem.
>>
>> Please advise.
>
> Did you change object.d_/object.di? Is the file really read?
> (use -v) If you could post a command line then I could try to
> figure out what is happening here.
>
> Regards,
> Kai
Well, I sat down today and ran the same build script I wrote last
night, and the error is gone. I can't even figure out how to get
it to reappear. I must have done something stupid.
I'm sorry for the distraction.
More information about the digitalmars-d-ldc
mailing list