[Robotgroup] Hauntlites- Review, thoughts, Lessons learned, and improvements

[Paul Atkinson]

Only mentioned the fuming nitric acid because Mike was trying lots of chemicals. I don't propose we do this in anyone's kitchen, etc. 
(Of course I've been etching PCBs in the kitchen...)

Personally I think that sanding the LEDs or sand blasting them is probably safe and adequate.

Paul

Denise Scioli <morg80 at hotmail.com> wrote: 


>From: Vern Graner 
>Reply-To: vern at txis.com,        Austin Robotgroup Mailing List 
>
>To: Austin Robotgroup Mailing List 
>Subject: Re: [Robotgroup] Hauntlites- Review, thoughts, Lessons    learned, 
>and improvements...
>Date: Fri, 29 Sep 2006 15:29:47 -0500
>
>Paul Atkinson wrote:
> > Think they using fuming nitric acid
>
>Yikes! So.. uh.. How about a dremel with a sanding drum? A bit
>safer/quicker maybe.. if not a dremel.. maybe an emery board?




YIKES is right. I don't think Kym would like fuming nitric acid along with 
the rosin for the kids and their cereal!!

Denise
>
>Vern
>
>--
>Vern Graner CNE/CNA/SSE    | "If the network is down, then you're
>Senior Systems Engineer    | obviously incompetent so why are we
>Texas Information Services | paying you? Of course, if the network
>http://www.txis.com        | is up, then we obviously don't need
>Austin Office 512 328-8947 | you, so why are we paying you?" ©VLG
>_______________________________________________
>Robotgroup mailing list
>Robotgroup at puremagic.com
>http://lists.puremagic.com/cgi-bin/mailman/listinfo/robotgroup


_______________________________________________
Robotgroup mailing list
Robotgroup at puremagic.com
http://lists.puremagic.com/cgi-bin/mailman/listinfo/robotgroup


 		
---------------------------------
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.