[Robotgroup] New Photos: Animatronic Baby Build

[Vern Graner]

Video of the baby prop operating:

http://www.youtube.com/hawgfly

:)

Vern

Vern Graner wrote:
> Eric & I went to visit Meredith and Carolyn at the secret laboratory of 
> Hawgfly productions:
> 
> http://www.hawgfly.com
> 
> Where we helped Meredith make a baby! :) We even took pictures! :D But 
> seriously, these folks were commissioned to make an animatronic prop 
> baby that could wave its arms for a television series. Though they had 
> gobs of experience in casting, molding, painting, makeup etc, they had 
> no practical experience in animatronics. They already had a prop rubber 
> "baby" to modify so all they needed was the electronics and the advice.
> 
> So, we all piled in the car and headed over to Hobbytown where they 
> bought a starter RC kit consisting of a Futaba 4 channel radio 
> transmitter, a receiver, batteries, charger and four servos (Futaba 
> S3004's) all for $119. I also suggested that they buy some hi torque 
> servos to use to move the arms as I expected that the rubber arms might 
> bind a bit with the rubber body of the prop baby. Add in two HITEC 
> servos to the bag and away we went.
> 
> Eric and I spent the afternoon coaching (but not actually DOING 
> anything) so they could get a good feel for how to work with the 
> components. Anyway, the result was a fully working animatronic prop 
> baby! Pictures of the progress are here:
> 
> http://www.notepad.org/baby
> 
> :)
> 
> Vern
> 

-- 
Vern Graner CNE/CNA/SSE    | "If the network is down, then you're
Senior Systems Engineer    | obviously incompetent so why are we
Texas Information Services | paying you? Of course, if the network
http://www.txis.com        | is up, then we obviously don't need
Austin Office 512 328-8947 | you, so why are we paying you?" ©VLG