[Robotgroup] H-Bridge driver?

[Gray Mack]

I have a spare L298 I will sell at cost but this is a raw chip and needs support components and driving signals. Ideally I would like to get an eaglecad board design that will make them simple to build. In some cases you can circuit bend a $5 radio control car from goodwill to utilize the bridge. You just have to figure out how to separate the RF from the drive components. Very old dot-matrix printers/plotters/scanners sometimes had stepper drivers that were on separate boards and easy to break out and sometimes bridgable I think. Sorry, none of these methods are easy, just cheap.

----- Original Message ----
From: Clendon Gibson <bsandyman at yahoo.com>
To: robotgroup at puremagic.com
Sent: Friday, May 4, 2007 9:58:32 AM
Subject: [Robotgroup] H-Bridge driver?


Does anyone have an H-Bridge driver they would be willing to give me or sell to me?

Failing that, does anyone have a driver they would recommend?


_______________________________________________
Robotgroup mailing list
Robotgroup at puremagic.com
http://lists.puremagic.com/cgi-bin/mailman/listinfo/robotgroup


 
____________________________________________________________________________________
Finding fabulous fares is fun.  
Let Yahoo! FareChase search your favorite travel sites to find flight and hotel bargains.
http://farechase.yahoo.com/promo-generic-14795097