[Robotgroup] Extruded aluminum to join 1/2" plywood sections?

[Robo Al]

How about just doing an angle cut on the plywood and using 2x4s for
the corners?

The plywood would screw/glue to the sides of the 2x4s and therefore
eliminate any sharp edges.

Another alternative is to have rubber corners. I've seen them used, but
I don't know of a source.

Alberto

On Sat, 2008-01-12 at 00:12 -0600, Vern Graner wrote:
> Ok, so I need to find a wayto make a clean and sharp-edge free 
> connection between three pieces of 1/2" finished plywood. This will make 
> a "kiosk" out of three pieces of plywood 6 feet tall and 3 feet wide. I 
> need to join the ends of the plywood and extruded alimiinum channel was 
> suggested. Where would Ieven start to lookfor something like this? Of 
> course, I'd have to find a place that is either in Austin, or that can 
> have it for me by the begining or middle of next week as I have 7 days 
> (well, make that 6 days now that we're past midnight! to have this 
> standing in the childrens museum.. No pressure... . ;)
> 
> Vern