What gcc to use for gdc master?

[Iain Buclaw via D.gnu]

On 4 June 2015 at 15:49, Dan Olson via D.gnu <d.gnu at puremagic.com> wrote:

> ketmar <ketmar at ketmar.no-ip.org> writes:
>
> > On Thu, 04 Jun 2015 00:15:37 -0700, Dan Olson wrote:
> >
> >> Starting a pull request for ARM and grabbed gdc master, but not sure
> >> what gcc it likes.  I tried gcc-5.1 but
> >>
> >> $ ./setup-gcc.sh ../gcc-5.1.0 found gcc version 5 This version of GCC
> >> (5) is not supported.
> >
> > make sure that you switched to 'gdc-5' branch.
>
> Does gdc-5 get folded back into master then, isn't it a release branch?
> I assume pull requests should be based on master?
>

All PRs should be based on master, and they get trickled down to release
branches as needed.

Master only works (or at least, has been tested) with the development
snapshot listed in gcc.version.  Which would be version gcc-6 now.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.puremagic.com/pipermail/d.gnu/attachments/20150604/e94346fd/attachment.html>